Gas work by a master gas fitter, not a handyman.
Switching to a gas range, adding a standby generator, or running a line to the patio means sizing the pipe for every appliance in the house, pressure-testing the system, and getting it inspected. Samuel is licensed to do the gas work himself, and he documents every test.
Hookups from $225 · written price before work starts

Gas Lines & Appliances prices
Starting prices for a typical North Alabama home. After a look at your setup, you get one written, flat price covering parts, labor, permit and clean-up.
Free estimates on gas lines & appliances. Send a few photos through the booking form and Samuel will reply with a written price, usually the same day.
Starting prices
- Appliance hookup on an existing gas stubRange, dryer, cooktopfrom$225
- New gas line to range or dryerUp to ~25 ft runfrom$595
- Gas logs / fireplace insert hookupfrom$395
- Standby generator gas lineUp to ~30 ft, sized to generatorfrom$995
- Outdoor kitchen or fire pit linefrom$795
- Pool heater gas linefrom$1,095
- Gas valve replacementfrom$225
When to call
- Buying a gas range, dryer or tankless water heater
- Adding a standby generator
- Building an outdoor kitchen, fire pit or pool heater
- Converting a wood fireplace to gas logs
- An old flexible connector or unsafe gas valve
- A home inspection flagged the gas piping
Every gas lines & appliances job
- Load calculation and pipe sizing for the whole system
- Black iron or CSST, bonded per code
- Pressure test, documented with photos
- Leak check on every joint
- Permit, inspection and utility coordination
- Appliance lit, tested and explained
Sizing is the part people skip
Every gas appliance draws a specific load in BTUs. Add a 199,000 BTU tankless water heater to a line that was sized for a furnace and a range, and something starves for gas. Samuel sizes the line for every appliance in the house before he quotes, which is basic engineering and still skipped more often than you'd think.
Natural gas or propane
Inside Huntsville and Madison most homes have natural gas from the local utility. Out in the county, many homes run on propane. Samuel works on both and will coordinate with your utility or propane supplier.
Gas Lines & Appliances FAQ
Do I need a permit for a gas line?
Yes. New gas piping requires a permit, a pressure test and an inspection before the utility will turn gas on. Samuel handles all of it.
Can you install the generator too?
Samuel runs and connects the gas supply. The generator's electrical transfer switch must be done by a licensed electrician. We're happy to coordinate with yours or recommend one.
Can I get a free estimate?
Yes. New gas line projects are quoted free. Send a few photos of the meter, the route and where the appliance will go.
Do you work on furnaces?
No. Gas connections to furnaces and other HVAC equipment fall under Alabama's HVAC licensing board, so call your HVAC contractor for those. We handle the gas piping that serves everything else.
Where we do gas lines & appliances
You might also need

Gas Leak Detection
Find and fix gas leaks, pressure testing, and safe re-lights after repairs.

Water Heaters
Tank and tankless installation, replacement and repair. Gas and electric.

Plumbing Repair
Leaks, running toilets, dripping faucets, bad valves and everything in between.
Get a straight answer and a written price.
Replacements and installs are quoted free. Send a few photos and Samuel will get back to you with a written price, usually the same day.

Plumbing Repair
Water Heaters
Gas Lines & Appliances
Gas Leak Detection
Drain Cleaning
Sewer Line Services
Leak Detection
Repiping
Water Softeners & Filtration
Fixture Installation
Emergency & Same-Day